- All OEM Slide Writing Removed
- Top, Front & Rear 45 Degree Chamfers
- Top Weight Reduction Pockets
- Side Weight Reduction Pockets
- Add Front Cocking Serrations
Available For: All Models, All Generations
Finishes: Cerakote Or Black Nitride
Great work, punctual, top notch.
A few years ago I had Primary Machine cut a G19 and G17 slide to match, both with burnt bronze cerakote. They came out better than expected! I could not have been happier. The G19 is still my daily carry gun. I love the tactile cuts allowing for press checks or just chambering a round. Again, very well done! You can trust these guys with your work!
I had the V1 cut + bob cut + DPP milling done on my Carry Optics Glock 34 and couldn’t be happier. Flawless all around with a turn around time of 1 week, I couldn’t believe it except that it was my fourth slide milled by Primary Machine and they've all been PERFECT and turned around in about a week. I will continue to use Primary Machine for all my slide milling and you should too!
The work on my slide was absolutely flawless. RMR fit snug and slide now weighs less than a standard slide. Logo is minimal and tastefully done. I regret not ordering the RMR cover plate! Folks did forget to remove the white sticker on my brand new battery. I thought that either my battery had not been installed or that my RMR was no longer functioning. Overall highly satisfied and will use P.M. for all my slide milling work!
I sent in my G17 for the UCC V1 and optic milling (DPP). It came back perfect and quickly. I will be sending in another for the same treatment.
Bought this cut and an RMR for my G19 a year ago. Gun now has more than 12k rounds through it with ZERO malfunctions, Minimal wear to cerakote. I am still extremely pleased with the work Bruce did on that so now a year later I bought 2 more RMR's and had another G19 and a 19x cut with this same cut. Once again I received PERFECT work on these two slides and look forward to running them just as hard as I have run my first slide cut by Bruce.
This is THE ONLY slide cut I recommend to friends. The slide + RMR weighs the same as the factory slide (great for reliability) and the RMR is held in place SUPER TIGHT since Bruce cuts the slide to fit that specific optic. This reduced the stress on the screws and shock transmitted to the RMR, increasing reliability of the optic.
If you are a real shooter then this is the slide cut for you.
Absolutely fantastic work, now having two different Glock slides cut and cerakoted by PM, I can happily say that this company does top tier quality work, and they have my business for life. Clean cuts and amazing cerakote leaves me wanting to send them more and more work. Great job PM and thanks for the fine work and amazing turn around time.
The Glock 17 that I had done was the 4th Glock that Primary Machine has done work on for me. They do outstanding work, very detailed and the turn around time is better than any other shop I have ever used. Try them, you won't be disappointed.
I have been using my g26 cut by primary machine for almost a year now, and I am very impressed and 100% satisfied. I had my g26 cut for an rmr and had the ucc v1 cut done as well. Very high quality work, and the black nitride finish has held up very well. The work was done quickly, and a fair price. I wont have the money to undertake another similar project for a while, but when I do I will return to primary machine.