Cerakote Any Slide

Perfect job! Better than factory, feels like it operates smoother too. Thank you!

Great job guys. Fast easy and excellent job

Excellent slide finish. Very good job guys.

When I received my slide back, I was amazed with the quality of the finish. It really looks amazing. Best bling to my gun, period. I will definitely use the service again, I would highly recommend to anyone.

First time using Primary Machine and they definitely over delivered. I expected to get my slide (Beretta 92FS) back in a month. I don't think it was gone 2 weeks. When I received an email in the first week saying it was shipped back I thought they were going to refuse the work for some reason. Nope, the black graphite cerakote was spot on and flawless, literally looking better than brand new. They also send instructions regarding break in for those who think everything should go back on smooth. FYI, plan to take your time finely honing areas of close tolerances after coating so you don't mess up their work (firing pin, safety, barrel, detent holes) and reassembly will be so much easier. Expect a very tight slide but just be patient, oil the rails and work the slide little by little. All around excellent first time experience!

Perfect cerakote finish with 0 flaws. Had the slide back in less than 2 weeks. Can’t beat the turn around time.

I sent my Glock 43x Mos slide out to this company to be cerakoted only and I could not be happier with the results. It was shipped out, cerakoted, and shipped back to me all within two weeks and I love the finish on it. Super clean work. I also sent them new sights that I requested them to install which they did so free of charge. I received my slide fully assembled and with my new sights installed and couldn’t be happier with the results.

Sent my CZ slide in for a cerakote refinish. Extremely impressed with the results and the speed in which I received it back!

This was my third time using Primary Machine and each time I've been impressed but this time I was wowed-amazed. I sent in a Staccato P slide that I had milled by C&hH Precision for a Holosun 509T. It was literally some of the worse machine work I had ever seen it was so bad that when I racked the slide the first time I cut my finger on the burrs that were everywhere from shabby machine work. Not only was the machine work bad the Cerekote was even worse. I pulled out a file and some sandpaper and did what I could with the slide. I boxed it up that same night and got it ready to ship to Primary Machine to be Cerakoted. A little over a week later my slide was returned in amazing condition all of the horrible machine work had been cleaned up and Cerakote job was top notch. Thanks again for the great job and going above and beyond you guys do AMAZING WORK!!!! I Did a Goggle review also pics of the amazing work are posted.