Trijicon RMR To Aimpoint ACRO Adapter

Model: Universal

Material: 7075 (Nearly twice the strength of 6061.)

Finish: Black Hard Anodize 

Hardware: Included (Torx key/screws/loctite/instructions)

Iron Sights: The sights offered above are for Glock only and will provide a lower 1/3 co witness on slides milled .150" deep (All Glock slides from us.)

Height Differences: .150" tall model is intended for RMR cuts milled between 0 and .150" deep. (From us, that means all Glocks, M&P's, VP9/40, P320, and P-07/09.) .200" model is for RMR cuts milled .151"-.200" deep. (From us, that means all P-10'C/F/S's in which the oem rear dovetail was milled out for the RMR.) If you don't have a micrometer to check your cut depth, simply call or email whoever milled your slide and they can provide that information.

Important notes:

*As of 5-1-2022 all .150" ONLY are now compatible with the Aimpoint ACRO and Steiner MPS .200" plates are not yet updated for the MPS.

*We guarantee our plates to be true to Trijicon prints. If our plate doesn't fit your cut - we can't control that as we didn't mill your slide.

*We guarantee 100% fitment with slides milled BY US. It is your responsibly to make sure our adapter will work with someone else's RMR milling. As long as your optic was milled to spec - you shouldn't have any problems using our plate. *Our plate WILL NOT work with Shadow Systems slides. Our plate will also not work with Brownells or Zev slides in which there are threaded posts for the optic to screw into. That is not standard as per Trijicon prints. You will incur our standard 20% restocking fee for plates returned due to not being compatible with someone else's optic milling.

*Trijicon calls for 6-32 threads, which is what we include with the adapter plate and what ALL Primary Machine RMR milling is threaded for. It's your responsibly to get the correct length/thread needed if a company didn't mill your threads the correct size.

*Depending on how deep your optic was cut and/or threads were cut by another company, you may have to trim the provided screws. (No trimming will be needed for any slide milled by us.) We will NOT be responsible for broken or stripped screws due to improper installation!